|
 |
|
SPECIFICATIONS
AUTOMEG/SUBMEG
Install one (1) completely enclosed solid state 12 pin plug-in electronics module to automatically monitor the motor winding insulation resistance. Each insulation tester must have a motor reset button and an emergency by-pass switch. Each automatic megger must have a power indicator light and a low megohm indicator light. Power source is to be 110 volts AC fused at 1.0 amp. The DC test voltage to be 500 volts. The output current to be limited to less than 3 micro amp. Must also have one (1) output circuit for external alarms.
When the motor winding leakage resistance drops to one (1) megohm an alarm system must be activated by the internal circuit of the insulation tester. The insulation tester shall measure the motor insulation resistance for no more than 10 seconds when the motor is off. Each automatic insulation tester must also include a test button to test the internal circuitry. The insulation tester is to be manufactured by AUTOMEG, Inc. or be an approved equal. Devices using DC test voltages less than 500 volts are not to be considered equal.
|
| |
|
• 352.742.2227/voice • 352.742.1162/fax • jhorvath@automeg.com •
• Automeg, Inc. • 12626 Double Run Ranch • Astatula, Florida 34705 •
| |
|
| | ©Copyright 2010 Automeg, Inc.
|
|
| |